check
check
check
check
check
check
check
check
check
check
The KJT-FZ crane anti-collision protection controller provides continuous optical distance monitoring and multi-stage safety interlocking for overhead traveling cranes, gantry equipment, and shared runway bays. Utilizing laser optical ranging, it tracks inter-crane separation up to 50 meters to prevent catastrophic runway collisions. KJT Sensors manufactures the KJT-FZ with fail-safe relay outputs and rugged anti-vibration housings for 24/7 industrial plant safety.
In heavy manufacturing bays where multiple overhead cranes operate along the same runway tracks, operator blind spots or drive brake failures can cause dangerous collisions. The KJT-FZ continuously measures inter-crane separation using high-frequency laser optical ranging.
A laser transmitter-receiver unit mounted on the crane targets a retro-reflector on the opposing crane or end-wall, calculating exact real-time separation distance with centimeter accuracy and providing independent safety supervision over crane travel.
Stopping heavy overhead traveling cranes carrying tons of steel requires controlled deceleration to prevent dangerous load sway. The KJT-FZ features dual-stage programmable safety relay outputs.
When separation closes below the Zone 1 threshold, the controller triggers audible alarms and activates the crane drive's deceleration circuit. If cranes continue into Zone 2, an emergency stop relay opens to initiate fail-safe mechanical braking before collision occurs.
The KJT-FZ controller unit features a high-visibility digital display and push-button programming interface. Technicians can configure warning and stopping distances directly on the front panel in centimeters.
Real-time distance readouts allow maintenance teams to verify optical ranging accuracy throughout the entire runway length during initial commissioning without requiring external laptops or programming tools.
Traveling mill cranes subject electrical equipment to severe continuous vibration, rail shocks, and high-voltage electrical noise from motor drives. The KJT-FZ controller is housed in a heavy-gauge industrial metal enclosure with internal vibration isolation.
Optically isolated input and output stages protect internal microprocessors from electrical line transients, ensuring dependable continuous safety oversight across all plant operational shifts.
| Technical Parameter | Specification & Feature |
|---|---|
| Ranging Technology | High-frequency laser optical time-of-flight distance measurement |
| Operational Range | Up to 50 meters continuous inter-crane tracking |
| Safety Interlocks | Dual-stage programmable deceleration (Zone 1) and stop (Zone 2) relays |
| Display & Setup | On-board digital distance display and push-button configuration |
| Vibration Protection | Reinforced industrial metal enclosure with shock-damped mounts |
| Target Reflector | Wide-angle optical retro-reflector panel accommodating crane sway |
Can the KJT-FZ protect three or more cranes sharing a single runway?
Yes, equipping each crane with forward- and rear-facing laser units and reflectors creates a fully coordinated anti-collision safety network.
Does crane sway or rail deflection cause loss of distance measurement?
No, the wide-acceptance retro-reflector target panel accommodates normal lateral crane sway and vertical runway deflection.
How are warning and stopping distance thresholds programmed?
Thresholds are entered directly via the front panel push-buttons and confirmed on the integrated digital display in real time.
What happens if a laser unit loses optical signal due to an obstruction?
The controller incorporates fail-safe signal loss logic that automatically initiates deceleration and alarm states if the target is obscured.